Validator PRO and Validator PRO-NT by JDSU

As a premium distributor of JDSU, Inycom announces new measuring equipment and ValidatorPRO-NT ValidatorPRO, portable solution that allows installers to certify network speed Ethernet networks, optical power measurements and verify the connectivity of WiFi networks.

 Both models offer the possibility Validator PRO certification Ethernet speeds and include optical power meter, however, ValidatorPRO-NT includes PoE functionality testing and testing of 802.11 b / g / n. Validator PRO / PRO-NT is a complete and economical solution to ensure network performance copper, fiber and wireless LAN facilities.
The ValidatorPRO is developed by JDSU with the objective of bringing low-cost solution to the increasing complexity of today's networks, which must support voice, data and video networks not only copper but also in fiber networks and Wireless LANs . The number of teams Validator enable installation companies to obtain greater savings in test and measurement, as the technicians can perform a single comprehensive tool for analysis of copper wiring, verify fiber networks in the core network, analyzing WiFi wireless networks for mobile users and ensure that the power supply terminals via PoE is working correctly.
To certify the performance of Ethernet cabling, the computer performs a test ValidatorPRO bit error rate (BER), maximum performance verifications of wiring, signal to noise ratio (SNR) measures Skew, continuity tests to detect open, short, wiring errors (miswires), high resistance links, broken wires, failures of high strength, accurate measurements of distance to fault and total distance. In relation to measures of power, ValidatorPRO includes a complete optical power meter wavelengths 850/1300/1310/1490/1550nm singlemode and multimode fiber to accommodate most existing networks, including optical links.
This new version includes an important set of features to make the network active measures: measures of PoE (Power over Ethernet) to ensure adequate power in the correct pin, use "port discovery" to ensure appropriate speeds and duplex capability is available, is connected to Gigabit Ethernet and carries out a ping to verify connectivity at Layer 3 of the hosts; ability to discover computers on the network via the CDP protocol "Cisco Discovery Protocol or LLDP" Link Discovery Protocol ", discovered and displays essential information regarding the operation and configuration of the 802.11 b / g / n.
Finally, the software includes a powerful ValidatorPRO the software tool "Plam" Um "to make a real engineering planning and reporting with network architecture, cabling organize information, assess the needs of the lengths of wiring and document the results.